RMRS
Uninterruptible power supply (UPS) systems are critical to the safety of maritime operations and offshore drilling platforms, supplying power to essential systems—including navigation equipment, communications, emergency lighting, and control systems—if the main power source fails. On offshore drilling platforms, these loads also include blowout preventer (BOP) systems, fire and gas detection systems, and drilling equipment control systems. Operating conditions on board ships and offshore drilling platforms are significantly harsher than those onshore: equipment must operate reliably in an isolated environment subject to high humidity, continuous vibration, a corrosive salt-laden atmosphere, and a high risk of total power loss. Explosion protection is also essential for offshore drilling platforms: UPS systems installed in hazardous areas (Zones 1 and 2) must hold ATEX/IECEx certification and comply with the IEC 60079 series of standards, for example by employing flameproof enclosure protection (Ex d). UPS requirements therefore focus primarily on maintaining the safety and operational integrity of both vessels and platforms. Compliance with these requirements is a prerequisite for operation under the class of a classification society such as DNV, ABS, BV, or LR. In addition, offshore drilling platforms are subject to the requirements of IEC 61892-6 (installation of electrical equipment on offshore units) and GOST R 70831-2023 (for facilities in the Russian Federation).
Russian Maritime Register of Shipping (RMRS) Requirements for UPS Systems
- Stable output parameters
- A mandatory bypass arrangement to supply the load from the shipboard power system in the event of an inverter failure
- Stable output parameters for supplying connected loads
- The UPS must maintain the rated voltage and frequency at the load terminals throughout the entire period of supplying the connected loads
- The equipment must remain operational at angles of heel and roll of 22.5° and angles of trim and pitch of 10°
- Voltage variation at the terminals of the battery connected to the converter must not exceed 12% of the rated voltage throughout the entire discharge period
- The UPS must supply the load while simultaneously charging the batteries at the maximum charging current
Our Solution
- Our UPS systems can serve as emergency or transitional sources of electrical power on vessels of any type
- Communication capabilities include Modbus RTU/TCP, RS-232, SNMP, and volt-free contacts for integration into industrial automation and control systems
- Strict adherence to the requirements of IEC 62040 for UPS systems and IEC 60079 for explosion protection
- The equipment complies with IEC 60079-1 for explosion protection on offshore drilling platforms and is designed to prevent ignition of explosive atmospheres in Zones 1 and 2
- Materials resistant to high temperatures, humidity, and salt mist exposure
- Up to 10 hours of backup power for critical systems, including the voyage data recorder (VDR) and emergency lighting
- Boost charging at the maximum charging current is interlocked with the ventilation system serving the battery room
The strengths of the service
Technical support from the development department
Of spare parts and components for repairs and scheduled maintenance
Locations – Ekaterinburg, Moscow, St.Petersburg
г. Москва, пр. Берёзовой Рощи, д. 4